Target area stabilization is important for achieving a precise anastomosis on a beating heart.

Suction technology (e.g., Octopus® 2 Tissue Stabilization System) provides secure attachment of the stabilizers to the epicardium. Lifting and separating the stabilizer heads pulls tissue taut to isolate and immobilize the target area (see figure below). Optimal stabilization is provided with motion reduction in all three planes (X, Y, Z). (11,17)

Compression stabilizers use downward force to compress the myocardium and restrict its motion (Figure 8). In fact, cardiac output has been shown to be temporarily decreased as a result of direct ventricular compression with reduced stroke volume. (19)

With CPB, a clear anastomotic site is obtained by cross-clamping the aorta, which stops all blood flow through the coronary arteries. In beating heart CABG, only proximal occlusion of the target coronary artery is required. Distal occlusion has not been found to be necessary unless poor visibility jeopardizes the precision of the anastomosis.

“Vessel occlusion is important from an antegrade flow perspective. We use a specially designed, very short-nosed bulldog.” (13)
—David Perkowski, M.D.

Many techniques for coronary artery occlusion are currently being used in conjunction with stabilization technology to prevent coronary trauma. In the following technique, a pledget and silastic tape are used to apply occlusion pressure (see figure below):
1. Place pledgeted silastic tape around the coronary artery.
2. Perform the arteriotomy while blood is flowing through the artery in order to minimize the risk of perforating the back wall of the artery.
3. Slide the pledget down while gently pulling up on the silastic tape just to the point of hemostasis.
4. Place a small titanium ligaclip on the silastic tape to maintain the occlusion.

View RealVideo Clip

In order to effectively perform an anastomosis on a coronary artery, whether or not the heart is beating, the anastomotic site must be cleared of blood to allow visualization for accurate suturing.

Several visualization devices are available on the market because a perfectly bloodless field is rare in beating heart CABG. Humidified air (e.g., Medtronic ClearView™ Misted Blower) has been shown to safely and effectively clear arteriotomies of excess blood and “parachute” open the arteriotomy to assist in suturing. The following parameters for misted blower devices provide sufficient humidification while preventing dessication of the coronary endothelium and surrounding tissue: (20)
Medical air flow at 2–5 L/min
Saline solution at 10–50 L/min under 150 mmHg pressure
Device held 5–10 cm from the anastomotic site
Malleable shaft to allow for unobstructed view of the target area

View RealVideo Clip

“It is critical to have an assistant who understands the use of the humidified CO 2 jet so you can see each suture.” (13)
—James C. Hart, M.D.

“We also use a blower/mister to clear the field of any other blood that’s coming retrograde. It is essential. You can’t do [beating heart CABG] without having a blower/mister.” (13)
—David Perkowski, M.D.